Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
- Suspension bracket
Forward suspension bracket
- Back suspension bracket
The general description
Diagnostics
- Service out of a workshop
The shock-absorber
Cylindrical spring
The bottom draught
The top draught
Lateral draught
The back bridge and the wheel bearing
Internal oil epiploon of the back bridge
The case of the back bridge
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
Brake system
Engines
Fuel system
Ignition system
Start system
Release system
Transmissions
Coupling
Transfer
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment
|
The bottom draught
Removal
|
|
Lift the car and remove a back wheel.
|
|
Jack (2) prop up the case of the back bridge (1).
|
|
|
Remove a forward fixing bolt (2) bottom draughts (1).
|
|
|
Remove a back fixing bolt (2) bottom draughts (1).
|
|
|
Installation
|
|
Establish the bottom draught (1) on a frame of the chassis (4) and the case of the bridge (5); the correct direction of bolts at installation is shown in drawing. A nut do not tighten.
Clean a jack from under the case of the back bridge (5).
Establish a wheel and tighten nuts of a wheel to the specified value of the moment of an inhaling. The inhaling moment: wheel nuts — 100 Н•м (10.0 kg th, 72.5 pounds-foots).
Lower the lift and in not loaded condition of the car tighten a forward bolt (2) and a back nut (3) bottom draughts (1) to the specified value of the moment of an inhaling.
The inhaling moment:
Forward bolt of the bottom draught (a): 100 Н•м (10.0 kg th, 72.5 pounds-foots)
Back bolt of the bottom draught (b): 90 Н•м (9.0 kg th, 65.0 pounds-foots)
|
|
A — the body Party
B — the Side of the bridge
1 — the bottom draught
2 — a forward bolt
3 — back a nut
4 — a chassis frame
5 — cases of the back bridge
6 — the body centre
7 — a body outer side |
|
|
|
|