Выкуп авто Сумы


Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
- Brake system
    Brakes
    Brake highway/hose the brake cylinder
    Forward brakes
   - Lay and back brake
       The general description
      - Diagnostics
         Check and adjustment
         Vehicle service
         Cable of a lay brake
         Brake drum
         Brake колодка
         The brake cylinder
         Back plate of a brake
    Antiblocking brake system (ABS)
Engines
Fuel system
Ignition system
Start system
Release system
Transmissions
Coupling
Transfer
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment





Brake drum

Removal

 PERFORMANCE ORDER

  1. Lift a vehicle and pull upwards the lever of a lay brake.
  2. Remove a wheel.
  3. Release the lever of a lay brake.
  4. Remove a back central console box (1) and release a lock nut of a cable lay
    Brakes (2).
1 — a cover of the lever of a lay brake
2 — a lock nut of a cable lay
Brakes
  1. Remove a brake drum (1) having turned off 8 mm bolts (2) (2 pieces).

Survey

Brake drum

 PERFORMANCE ORDER

  1. Examine a drum, how much it is pure. Check up deterioration of a brake surface, having measured its internal diameter.
    • Internal diameter of a brake drum
      • "a": the standard: 220 mm (8.66 inches)
    • Deterioration limit: 222 mm (8.74 inches)
  1. Each time at removal of brake drums it is necessary to clear and check carefully them, whether there are no cracks, notches, deep furrows.
  2. Drum with cracks, notches or grooves
  3. To use a drum with cracks it is unsafe, it is necessary to replace it.
  4. Do not try to weld треснутый a drum.
  5. Grind all lungs заcечки. Deep or extensive notches will cause superfluous deterioration of a brake overlay, therefore it will be necessary to cover a brake surface of a drum again. If brake overlays are a little worn out also a drum has grooves, it is necessary to polish a drum with a thin emery paper, but not to overturn.

When the drum is removed, examine, whether there is no leak of a brake liquid in the wheel cylinder. Eliminate leaks if they are.