Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
Brake system
- Engines
   - Mechanical part of engine G16
       The general description
      - Routine maintenance
         Compression check
         Check of depression of the engine
         Check of pressure of oil
         Klapannyj backlash
         Filtering element of the air filter
         Cover of a head of cylinders
         The case throttle заслонок and an inlet collector
         Collector of the fulfilled gases
         Drive belt газораспределительного the mechanism and the tension device for a belt
         Маслосборник and a grid of the oil pump
         The oil pump
         Коромысло the valve, an axis коромысел and a cam-shaft
         Valves and head of the block of cylinders
       Piston rod, piston rings, rods and cylinders
      The special tool
      Necessary service materials
      Technical characteristics of the rotating moment of an inhaling
    Mechanical part of engine J20
    Engine cooling
Fuel system
Ignition system
Start system
Release system
Transmissions
Coupling
Transfer
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment





Cover of a head of cylinders

Removal

 PERFORMANCE ORDER

  1. Disconnect a negative cable from the accumulator.
  2. Remove knots of the coil of ignition with a high voltage wire.
  3. Disconnect the valve of compulsory ventilation and a hose сапуна from a head cover.
  4. Separate a rope of an accelerator from a clip.
  1. Uncover heads of the cylinder (1) a lining of a cover of a head of cylinders (2) and O-shaped rings (3).

Installation

 PERFORMANCE ORDER

  1. Establish O-shaped rings (2) and a lining of a cover of heads of cylinders (1) on a cover of heads of cylinders (3).

Do not forget to check up each of these details on presence of any damages or breakages before installation, and make replacement if damages are found out.


  1. Establish a cover of a head of cylinders on a head of cylinders and fasten cover bolts to the specified rotating moment. The rotating moment of an inhaling: a bolt of a cover of a head of the cylinder () — 11 Н•м (1.1 kg th, 8.0 pound on foot).

At installation of a cover of a head of the cylinder track, that the lining of a cover of a head of the cylinder or O-shaped rings have not fallen or have not moved a little.


  1. Fix a rope of an accelerator a clip.
  1. Establish knots of the coil of ignition with a high voltage wire.
  2. Attach the valve of compulsory ventilation and a hose сапуна to a head cover.
  3. Connect a negative cable to the accumulator.