Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
Brake system
Engines
Fuel system
Ignition system
Start system
Release system
- Transmissions
- Mechanical transmission (type 1)
The system description
Diagnostics
- Service out of a workshop
Oil for a transmission
The gear change lever
The illumination switch
Back fixture of the engine
Transmission removal
Transmission installation
The case-extension piece (for model with a drive on two wheels and engine G16 and J20)
Oil epiploon of the case-extension piece (for model with a drive on two wheels and engine G16 and J20)
Mechanical transmission (type 2)
Automatic transmission (4 A/T)
Coupling
Transfer
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment
|
The illumination switch
|
|
Refrain from work, while the central exhaust pipe hot. |
Removal and installation
|
|
At switch replacement be cautious, that the dust has not got to a transmission through a switch aperture. |
|
|
Lift the car.
Remove сцепку () switch wires.
Type 1 and type 2
|
|
1 — сцепка the illumination switch
2 — forward карданный a shaft |
Type 3
|
|
1 — сцепка the illumination switch
2 — forward карданный a shaft |
Replace the switch of illumination (1), connect and fix, as was in a starting position.
The inhaling moment:
(a): 20 Н•м (2.0 kg th, 14.5 pounds-foots) (Type 1)
(a): 45 Н•м (4.5 kg th, 32.5 pounds-foots) (Type 2 and type 3)
After replacement of the switch of illumination check up serviceability of work of the switch, having turned the ignition key in position "INCL." (ON), and transfer having switched in backing position. After check of work of the switch, switch off it.
Type 1
|
|
2 — the central exhaust pipe |
|
|
Check
|
|
Open a latch and disconnect сцепку the illumination switch.
|
|
Work of the switch of illumination (1) can be checked up.
|
The chain should become isolated on its terminals only when the switching lever is in backing position.
On termination of check attach сцепку and clip wires how they have been connected initially.
|
|
At switch replacement be cautious, that the dust has not got to a transmission through a switch aperture. |
|
|
|
|