Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
- Steering
Suspension bracket, wheels and tyres
Adjustment of corners of installation of wheels of a forward suspension bracket
System of the hydraulic booster of a wheel
- Steering wheel and steering column
- Steering wheel and steering column the safety not equipped with a pillow
The general description
Diagnostics
- Service out of a workshop
Steering wheel
Podrulevye switches
Steering column (at not a cabriolet)
The top shaft of a steering (at not a cabriolet)
Steering column (at a cabriolet)
The steering lock (the ignition switch)
The bottom shaft of a steering
Check of a steering column on presence of damages at failure (at a cabriolet)
Check of a steering column and the top shaft of a steering on presence of damages at failure (at not "cabriolet")
The lever of an adjustable unblocking of a steering column
Specifications of the moment of an inhaling
The special tool
Steering wheel and steering column with a safety pillow
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
Brake system
Engines
Fuel system
Ignition system
Start system
Release system
Transmissions
Coupling
Transfer
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment
|
Steering column (at a cabriolet)
|
|
When the steering column is removed from the car, it is very easy for damaging. If it to drop vertically, the steering shaft can break or can ослабнуть plastic pins which regulate length of a column; if against it to lean, it can be bent or deformed. Any of the listed damages can worsen ударопоглощающие properties of a column. Weakening fixing bolts and nuts of a steering column, be convinced that the steering column and the bottom steering shaft are separated. If before easing of fixing bolts and nuts a steering column and the bottom steering shaft not to separate, it can damage the bearing of the bottom steering shaft. |
|
|
At carrying out of service of a steering column or any knots established on it it is necessary to remove a steering wheel. But if the steering column acts in film to provide only access to components of the panel of tools, the steering wheel can to be removed from a column. |
Removal
|
|
Disconnect "minus" (–) a battery cable.
Remove a steering wheel and подрулевые switches if it is required. Sections the Steering wheel and Podrulevye switches See in the given Chapter.
If a steering wheel and \or подрулевые switches remain on a place, execute following manipulations:
Turn a steering wheel so that forward wheels of the car looked directly forward.
Turn the ignition switch in position “LOCK” and take out a key.
Uncover a steering column (1).
Disconnect all cables of following knots:
Contact spiral and подрулевых switches
The ignition switch
Elements of anticreeping system (if are available).
|
|
* — If enter into a complete set |
|
|
Put стыковочные labels (3) on муфту a shaft (2) (from outside columns) (1) that on them correctly to establish into place.
|
Having unscrewed a bolt (4) from outside columns on муфте a shaft and having weakened a bolt (5) from outside the bottom shaft, pull муфту a shaft (2) towards the bottom shaft (as shown arrows in drawing more low).
|
|
1 — a steering column
2 — the bottom shaft
3 — the bottom steering shaft
4 — муфта a shaft
5 — a bolt |
Unscrew fixing bolts of a steering column (6 pieces) (2).
|
|
1 — a steering column
2 — fixing bolts of a steering column
3 — the bottom epiploon of a steering column |
|
|
If there is a cable of blocking (1) switches (key), unscrew a bolt (2) cables of blocking of the switch (key), and then disconnect a cable from the ignition switch.
|
Remove a steering column from the car.
|
|
Survey
Check up serviceability of a steering column and presence of damages as it is described in the given section in the Head Check of a steering column on damages at failure (at a cabriolet).
Installation
|
|
- After fixing bolts of a steering column are tightened, tighten bolts муфты a steering shaft.
- After the bottom bolts of a steering column are tightened, tighten the top bolts of a steering column.
|
|
|
Be convinced that forward wheels and a steering wheel are in the position corresponding to rectilinear movement of the car.
If there is a cable of blocking of the switch (key), fix it on the ignition switch.
Establish a steering column (1) on the panel (4) and the top fixture so that the thickening of the bottom epiploon of a steering column (3) was projected through an aperture in the panel in an engine compartment. Tighten at first the bottom bolts of a steering column (2) (4 pieces), and then the top bolts (5) (2 pieces) the specified value of the moment of an inhaling. The inhaling moment: a fixing bolt of a steering column — 23 Н•м (2.3 kg th, 17.0 pounds-foots).
|
|
In an engine compartment.
|
|
|
Dress муфту a steering shaft (1) on a steering shaft (2), having combined the labels (3) put before removal.
|
|
|
Fasten a bolt муфты a shaft (from outside columns) to муфте a steering shaft (1). At first tighten a bolt муфты a shaft (from outside columns) (2) to the specified value of the moment of an inhaling, and then a bolt муфты a shaft (from the bottom party of a shaft) (3) to the specified value of the moment of an inhaling. The inhaling moment: a bolt муфты a shaft — 25 Н•м (2.5 kg th, 18.0 pounds-foots).
|
If have been removed подрулевые switches, establish them into place. Switches see in the given Chapter Razdel Podrulevye.
Connect all wires which have been disconnected before removal.
Establish a cover of an aperture of a steering column (1).
|
|
* — If enters into a complete set |
If the steering wheel has been removed, establish it as the Steering wheel is described in the given Chapter in Section.
Connect "minus" a battery cable.
|
|
|
|