Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
- Suspension bracket
    Forward suspension bracket
   - Back suspension bracket
      The general description
      - Diagnostics
         The diagnostic table
         Shock-absorber check
         Check of the bottom draught, the top draught, lateral draught
          Check of the case of the bridge and cylindrical spring
         Check of a stopper of the bearing and internal oil epiploon of the bridge
         Check of a wheel disk, nut and the bearing
       Service out of a workshop
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
Brake system
Fuel system
Ignition system
Start system
Release system
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment

Shock-absorber check


    Check up on presence of deformations or damages. Check up plugs on deterioration or damages. Check up on presence of signs of leak of oil. Replace any faulty parts.

At work with the back shock-absorber in which there is a gas under a high pressure, it is necessary to observe following safety measures:

  • Not to assort the shock-absorber.
  • Not to place it in fire.
  • Not to store in its places where it can become hot.
  • Before recycling it is necessary to drill in it an aperture in a place specified in drawing by an arrow, and to let out gas and oil. For this purpose put the shock-absorber sideways.
  • Gas in itself is harmless, but at its exit the shaving formed at drilling, therefore necessarily can take off put on goggles.

"And": drill an aperture in diameter about 3 mm (0.12 inches).