Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
- Brake system
   - Brakes
      The general description
       Diagnostics
      The diagnostic table
       Check and adjustment
      Specifications - an inhaling twisting moment
      Necessary materials for service
      The special tool
    Brake highway/hose the brake cylinder
    Forward brakes
    Lay and back brake
    Antiblocking brake system (ABS)
Engines
Fuel system
Ignition system
Start system
Release system
Transmissions
Coupling
Transfer
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment

Читаем тут: https://snovonovo.ru



Brake system

Brakes

The general description

For the vehicles equipped with additional system "air bag" (a safety air cushion):

    Service of components of an air cushion of safety ("air bag") and near to them or works with electroconducting should be carried out only by authorised dealer SUZUKI. Non-observance of security measures can lead to inadvertent operation of system or put system out of action. Any of these two conditions can lead to a serious trauma. Works on maintenance service should be begun not earlier than in 90 seconds after the ignition switch is translated in position LOCK/ЗАМОК and the negative cable is disconnected from the battery. Otherwise the system can be activated reserve energy of the module of sensor controls and diagnostics.

    At survey and service of the vehicle equipped АБС, necessarily at first address to the Head Antiblocking brake system (ABS).
  • All fastenings of brakes are the important elements of fastening and can affect work of the vital details and systems, and-or considerably to affect repair cost. It is necessary to replace them with details having the same number or equivalent if such replacement is necessary. Do not use for replacement of a detail of the worst quality or substitutes. It is necessary to observe the specified values of a twisting moment of an inhaling at assemblage to provide long service life of all details. It is not necessary to use welding as it can lead to extensive damages and metal easing.

When it is pressed foot brake, in the main cylinder the hydraulic pressure putting in action pistons (two in front and four behind) is created.

The main cylinder – two-planimetric. Brake highways are connected to the main cylinder and form two independent contours. One of them connects forward brakes (right and left), and another – back brakes (right and left).

For vehicles without АБС between the main cylinder and a back brake the valve of restriction of brake effort is included in these contours to proportionally loading (LSPV).

In the given brake system, for brakes of forward wheels the disk brake system, and for back brakes – system of drum-type type is used. (Conducting/supporting колодки).

System of a lay brake - mechanical. It puts brake effort only to back wheels by means of a cable and system of mechanical interrelations. Same brake колодки are used as for lay, and a foot brake.

Drawing shows a vehicle with the left wheel.

For a vehicle without АБС

1 — the main cylinder
2 — 4-foreign connection
3 — 2-foreign connection
4 — LSPV
5 — the case of a back shaft
6 — hydraulic block ABS
A — the forward party

For a vehicle with АБС

1 — the main cylinder
2 — 4-foreign connection
3 — 2-foreign connection
4 — LSPV
5 — the case of a back shaft
6 — hydraulic block ABS
A — the forward party