Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
Brake system
Engines
Fuel system
Ignition system
Start system
Release system
Transmissions
Coupling
Transfer
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
- Electric equipment
- Body electric equipment
The basic description of the block of management of body electronics
Codes of diagnostics of malfunctions
- The general description
Safety measures at work
Colour designations of wires
Connecting socket
Illumination system
Electric equipment system
Tools/information for drivers
|
Safety measures at work
At performance of the works connected with an electric equipment, attentively observe following safety measures not to damage electric components and not to admit fire distribution.
At removal of the storage battery from the car or removal of cables from plugs of the battery for check or carrying out of service works, check up that ignition and all power consumers are switched off. Transistor components otherwise can be damaged.
|
|
At removal of plugs from the storage battery, in the beginning, remove the negative plug (-), and then positive (). |
Connection of plugs to АКБ occurs in return sequence.
|
|
At separation коннекторов, never pull for wires. At first отщелкните a clamp коннектора and, then, separate, having pulled them every which way, holding for cases of sockets. |
|
|
At connection коннекторов, also hold them and insert, while they reliably will not be latched (click) will be audible. |
|
|
At conducting installation, fix its clip-on earrings that there were no sagged sites. |
|
|
At installation of spare parts, watch that wires did not intertwine and did not touch other parts of the car. |
|
|
To prevent possible damage of conducting, protect it from contact to the car knots, forming acute angles, by means of an insulating tape or similar materials. |
|
|
At safety lock replacement, be convinced that it of necessary capacity. Use of safety locks большей capacities can cause damage of electric components and to ignition. |
|
|
Always carefully address with electric components (the computer, the relay etc.) and do not throw them. |
|
|
At performance of works which cause rise in temperature from above 80 C nearby with electric components, beforehand remove теплочувствительные components. |
|
|
Do not suppose water hit on коннекторы and electric components, it can become the reason of damages. |
|
|
At use of a tester for check of indissolubility of connection or for pressure check, insert щуп a tester from outside wires. |
|
|