Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
Brake system
Engines
Fuel system
Ignition system
Start system
Release system
Transmissions
Coupling
Transfer
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
- Electric equipment
- Body electric equipment
The basic description of the block of management of body electronics
- Codes of diagnostics of malfunctions
Check of a diagnostic code of malfunctions (КДН)
Clearing of a diagnostic code of malfunction (КДН)
The table of a diagnostic code of malfunction (КДН)
The scanner information
Terms and the formulations used in the scanner
The table of signals on scanner SUZUKI exit in a test mode
The general description
Illumination system
Electric equipment system
Tools/information for drivers
|
Codes of diagnostics of malfunctions
Check of a diagnostic code of malfunctions (КДН)
With scanner "SUZUKI" use
|
|
To prepare scanner "SUZUKI".
|
|
At the switched off ignition to attach the device to a socket of the data link (EFFICIENCY) (1), being under the instrument panel from outside armchairs of the driver. The additional device (): scanner "SUZUKI".
|
Include ignition.
Read the diagnostic code of malfunction represented on the display of scanner "SUZUKI" and unpack it or write down.
For the additional information the Directory of the mechanic see.
If information transfer process between the management block кузовной electronics and scanner "SUZUKI" is impossible, check up, whether this process with the management block on other car is carried out.
If information transfer process in this case is carried out, scanner "SUZUKI" is in good repair. Then check up a socket of the data link and the consecutive chain which is in the car from which information transfer process it was not possible to carry out.
After check end, switch off ignition and disconnect scanner "SUZUKI" from a data link socket.
|
|
Without scanner "SUZUKI" use
|
|
|
|
Check up that with ignition inclusion display "Hours/rate" has joined also.
|
Using a repair wire (2), earth contact of the diagnostic switchboard in a place of control connection (3).
At the included ignition and the idle engine, read КДН, represented on display "Hours/rate". Find conformity in the Table of a diagnostic code of malfunction (КДН).
After check will be finished, switch off ignition and disconnect a repair wire from a place of control connection.
|
|
2 — a repair wire
3 — control connection
4 — "weight" of the case
5 — an air inlet fragment |
|
|
|
|