Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
Brake system
Engines
Fuel system
Ignition system
Start system
Release system
Transmissions
Coupling
Transfer
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
- Electric equipment
   - Body electric equipment
       The basic description of the block of management of body electronics
      - Codes of diagnostics of malfunctions
         Check of a diagnostic code of malfunctions (КДН)
         Clearing of a diagnostic code of malfunction (КДН)
         The table of a diagnostic code of malfunction (КДН)
         The scanner information
         Terms and the formulations used in the scanner
         The table of signals on scanner SUZUKI exit in a test mode
       The general description
    Illumination system
    Electric equipment system
    Tools/information for drivers





Clearing of a diagnostic code of malfunction (КДН)

After repair or replacement of a faulty detail () (knot, the mechanism), erase all КДН, having executed following operations.

Using scanner "SUZUKI"

 PERFORMANCE ORDER

    Connect scanner "SUZUKI" to a data link socket in the same way, as well as at performance of check ДКН. Include ignition. Erase КДН according to instructions on the scanner display. For the additional information the Directory of the mechanic see. After КДН it will be erased, switch off ignition and disconnect the scanner from a data link socket.

Without scanner "SUZUKI" use

 PERFORMANCE ORDER

    Switch off ignition. Using a repair wire (2), connect feeding plug of a diagnostic socket to weight of the case (3). Include ignition, at the kept connection described in point 2.
2 — a repair wire
3 — the feeding plug
4 — an air inlet fragment
    Execute 5 cycles of connection/detachment of a repair wire from "weight" of the case within 10 seconds with an interval in 1 second (it is admissible большее quantity of cycles) (the wire is connected by other end to the feeding plug of a diagnostic socket).

About — it is opened
S — it is closed
Т — about 10 seconds

    After clearing end, switch off ignition and disconnect a repair wire from a socket of a control socket.