Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Suspension bracket
- Wheels and tyres
   - The general description
      Tyres for replacement
      Wheel replacement
      Kolpachkovye nuts and wheel hairpins
    Servicing and small adjustment
    Service out of a workshop
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
Brake system
Fuel system
Ignition system
Start system
Release system
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment

Tyres for replacement

In need of replacement of tyres it is necessary to replace with tyres of that type by which the car has initially been completed. See the Table on tyres. The tyres established at replacement, should be the same size, a design and calculated on the same loading, as initially established.

Use of tyres of other size or type can affect a course and driving, speedometer/odometra calibration, a road gleam of the car and a backlash between the tyre or противобуксовочной a chain and a body and the chassis.

Do not put on one car different types of tyres, for example, radial, diagonal and diagonal with reinforced брекером except for cases of emergency necessity as it can strongly affect driving, and it is possible to run away.

It is recommended to establish new tyres in pairs on one axis. If it is required to replace only one tyre, it should be that steam room, at which biggest protector to counterbalance brake coupling.

Pressure in tyres is measured in metric system in килопаскалях (kPa). In the tablet on tyres pressure in tyres usually is underlined both in килопаскалях (kPa) and in pounds square inch (psi).

Metric devices for pressure measurement are on sale in shops of tools. In the table resulted at the left transfer of the most ordinary values of pressure in tyres from килопаскалей (kPa) in pounds on square inch (psi) is shown.


    : 1 psi = 6.895 kPa : 1 kgf/cm2 = 98.066 kPa