Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
Brake system
Engines
Fuel system
- Ignition system
   - System of ignition for engine G16
       The general description
       Diagnostics
      - Vehicle service
         Check of a spark of ignition
         Check of time of an advancing of ignition
         High voltage wire
         Assemblage of the coil of ignition (an igniter and the ignition coil)
         Spark plug
         The resistor an ignition advancing (if it is established)
         CMP-sensor control
         Шумоподавитель
      The specification, inhaling twisting moment
      The special tool
    System of ignition for engine J20
Start system
Release system
Transmissions
Coupling
Transfer
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment





High voltage wire

Removal

 PERFORMANCE ORDER

    Remove a wire of a high voltage (2) from the coil of ignition (1), keeping its cap.
    Extend a wire of a high voltage (2) of a spark plug, keeping its cap.
  • Removal of wires of a high voltage together with clips can damage wires inside (a wire of high resistance).
  • For the same reason, disconnect wires, keeping for a cap.

Survey

 PERFORMANCE ORDER

    Measure resistance of a wire of a high voltage, using an ohmmeter. Resistance of a wire of a high voltage: 4-10 to / m (1.2 - 3.0 to / foot).
    Check up, whether there is no for damages, a permission and corrosion of conclusions. If result of check unsatisfactory, replace a wire () a high voltage.

Installation

Establish a wire of a high voltage (2) on a spark plug and the coil of ignition (1), keeping its cap.


  • Never use a metal conductor of a high voltage for replacement.
  • Completely insert caps when establish high voltage wires.