Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
Brake system
Engines
Fuel system
Ignition system
Start system
Release system
- Transmissions
Mechanical transmission (type 1)
Mechanical transmission (type 2)
- Automatic transmission (4 A/T)
The general description
Diagnostics of an automatic transmission
Safety measures at diagnostics of malfunctions
Visual survey
- Service out of a workshop
Liquid level
Liquid replacement
Hoses of a cooler of oil
Cable of a throttle of an automatic transmission
The manual selector
Gear change cable
The switch (gauge) of a range of transmission
The gauge of speed on an exit of an automatic transmission
The interruption switch on demand
Solenoidal valves
The switch of change of a food \norm
Tubes of a cooler of oil
System of blocking of brakes
System check
Coupling
Transfer
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment
|
Gear change cable
Тип-1
Тип-2
Adjustment (for type-1)
|
|
Before a nut tightening on the cable end switch the lever of a choice of transfer to position “N”.
Also switch in position “N” the lever of a manual choice of transfer.
|
|
Be convinced that under the above described conditions the nut and cable connection has a backlash.
- If the cable of a choice of transfer has been shifted, move it in a direction of arrow C, against the stop, and then be convinced that the choice lever is in position “N”.
|
|
|
1 — the gauge (switch) of position of transmission
2 — a cable of a choice of transfer
3 — the lever of a manual choice of transfer
4 — the hinge of a cable of a choice of transfer |
Turn nut A a hand while it will not concern the hinge of a cable of a manual choice of transfer.
Then tighten nut B a wrench.
After installation of a cable of a choice of transfer check up the following:
Push the car when the lever of a choice of transfer is switched in position “P”. The car should not move.
The car cannot go in position “N”.
The car can go in position “D”, “2”, and “L”.
The car can reverse in position “R”.
|
|
1 — the hinge of a cable of a choice of transfer
And — to level the cable hinge
In — to tighten a wrench |
|
|
Adjustment (for type-2)
|
|
Ослабьте a nut (1) levers of manual switching (from outside a choice cable).
Switch the lever of a choice of transfer to position “N”.
|
|
Level the central line (2) on a shaft of the manual valve (3) with a zero line “N” (4).
|
Tighten a nut (1) levers of manual switching (from outside a cable of a choice of transfer) to the specified value of the moment of an inhaling. The inhaling moment: a nut of the lever of manual switching (a) — 19 Н•м (1.9 kg th, 14.0 pounds-foots).
After installation of a cable of a choice of transfer check up the following:
Push the car when the lever of a choice of transfer is switched in position “P”. The car should not move.
The car cannot go in position “N”.
The car can go in position “D”, “2”, and “L”.
The car can reverse in position “R”.
|
|
|
|