Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
Brake system
- Engines
Mechanical part of engine G16
Mechanical part of engine J20
- Engine cooling
The general description
Diagnostics
- Maintenance service
Check of level of a cooling liquid
Service and repair of system of cooling
Washing and filling of system of cooling
Regulation and check of a tension of a belt of the cooling fan
Vehicle routine maintenance
Necessary service materials
Technical characteristics of the rotating moment of an inhaling
Fuel system
Ignition system
Start system
Release system
Transmissions
Coupling
Transfer
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment
|
Washing and filling of system of cooling
|
|
Uncover a radiator when the engine will cool down. Slowly turn a cover on the left until it will not reach a point of "feet" (do not press when turn). Wait while pressure will be dumped (a hissing sound specifies in it), then press a cover and continue to turn on the left.
|
|
In order to avoid a burn do not uncover a radiator, while the engine and a radiator still hot. A burning liquid and steam can be splashed out under pressure if the cover is removed too early. |
Having uncovered a radiator, start the engine, the top hose of a radiator (it shows that the thermostat is opened and the cooling liquid moves on system) will not heat up yet.
Switch off the engine and open a drain stopper of a radiator to merge cooling liquid.
|
|
Close a drain stopper (1). Add waters while the system will not be filled, and start the engine while the top hose of a radiator again will not heat up.
|
Repeat points 3) and 4) some times until the merged liquid does not become almost colourless.
Merge cooling system, and then strong close a drain stopper of a radiator.
Disconnect a hose from the tank (1). Remove the tank and merge a liquid. Потрите also clean the tank inside with soap and water. Well wash out its pure water and drain. Establish the tank and a hose into place.
Add a mix 50/50 этилен гликолевого antifreeze of high quality and water in a radiator and the tank. Fill a radiator to a bulk mouth and the tank to a mark of level "FULL" (2). Establish a tank cover, having levelled arrows (4) on the tank and a cover.
|
|
1 — a hose from the tank
2 — a mark of high level
3 — a mark of low level |
Start the engine with an open cover of a radiator until the top hose of a radiator will not heat up.
At the engine idling, fill in cooling liquid in a radiator to level of a jellied mouth. Establish a radiator cover, having convinced that cover clips are levelled with a tank hose.
|
|
|
|