Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
Brake system
Engines
Fuel system
Ignition system
Start system
Release system
Transmissions
Coupling
Transfer
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
- Electric equipment
Body electric equipment
Illumination system
- Electric equipment system
The general description
Diagnostics
The works made on the car
- Major repairs
- The generator
Removal
Installation
Dismantling [Type 60 A]
Dismantling [Type 70 A and 80 A]
Survey [Type 60 A]
Survey [Type 70 A and 80 A]
Replacement of brushes
Assemblage [Type 60 A]
Assemblage [Type 70 A and 80 A]
Specifications
The inhaling moments
Tools/information for drivers
|
Survey [Type 60 A]
Rotor
|
|
Using an ohmmeter, check up electroconductivity between contact rings of a rotor. If there is no electroconductivity, replace a rotor. Standard resistance: 2.5 - 2.9.
Using an ohmmeter, check up, whether there is no electroconductivity between a contact ring and the rotor core. If there is an electroconductivity, replace a rotor.
Check up contact rings, whether there is no roughness or a deposit. If they rough or are a deposit, replace a rotor.
|
|
Статор
|
|
Using an ohmmeter, check up electroconductivity of all contacts. If there is no electroconductivity, replace статор.
Using an ohmmeter, whether check up there is no electroconductivity between contacts of the coil and the core статора. If there is no electroconductivity, replace статор.
|
|
1 — статор
2 — contact статора |
|
|
Brush and щеткодержатель
|
|
Check up each brush on deterioration, having measured its length.
|
|
If the brush is worn out to a limit, replace a brush.
Length of a brush "a"
The standard: 16 mm (0.63 inches)
Limit: 2 mm (0.08 inches)
|
|
|
The rectifier
|
|
Using an ohmmeter, check up electroconductivity between cases of the top and bottom rectifiers and contact of each diode.
Check up both directions, having changed щупы an ohmmeter. In each case there should be only unilateral conductivity. If result of check unsatisfactory, replace the rectifier.
|
|
Check up unilateral electroconductivity between contacts and three diodes similarly described in item 1.
|
|
|
1 — the rectifier
2 — diode contact |
|
|
The condenser
Check up condenser capacity. Condenser capacity: 0.5 F.
|
|
1 — the rectifier
2 — the condenser |
|
|