Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
Brake system
Engines
Fuel system
Ignition system
Start system
Release system
Transmissions
Coupling
- Transfer
The general description
Diagnostics
- Service out of a workshop
Oil of a distributing box
The gear change lever
The switch of transfer of the all-wheel drive car
Oil epiploons of transfer
The gauge of speed
Back fixture of the engine
The transfer module
Removal
Installation
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment
|
The gear change lever
Removal
|
|
|
|
Remove covers (1) from the central console boxes.
|
Remove the top cover (2) back central console boxes.
Remove 6 bolts, and then a back central console box.
Uncover a casing.
|
|
Lift a casing №3, a casing №2 (1).
|
Remove a casing clip, and then lift a casing №1 (2) from the case of the lever of switching of a transmission (3).
Fingers press downwards a cover of the case of a gear change (4), turn it counter-clockwise and pull out the lever of a gear change (5).
|
|
Check
|
|
Check up the bottom part of the lever of a gear change and adjusting sheet of the lever on excessive deterioration.
Check up a casing on damages.
If necessary, replace or correct.
|
|
If adjusting bolts (1) levers of switching are replaced or drawn, tighten them to the specified value of the moment of an inhaling.
|
At replacement of adjusting bolts (1) levers of switching the clamp of a carving for carving blocking is required. “B”: a clamp of a carving 99000-32110. The inhaling moment (a): 17 Н•м (1.7 kg th, 12.5 pounds-foots).
Put greasing on rotating parts and a nest, then establish the gear change lever. “A”: greasing 99000-25010.
|
|
Establish the lever of a gear change (2) in the lever case.
|
Having pressed a hand downwards a cover of the case of the lever of a gear change (1), turn it (1) clockwise.
|
|
Establish a casing №1 (1) from within salon and reliably fix its new clip (2).
|
|
|
Establish a casing №2 (2) with a cover of a casing (3) and an arm of a console box (1).
|
Establish a console box.
|
|
Be convinced that the extending end of a casing №3 was combined with a console box. |
|
|
Having combined a casing №3 (1) with covers (2), establish covers (2) on the central console boxes. (a): 17 Н•м (1.7 kg th, 12.5 pounds-foots).
|
|
|
|
|