Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
Brake system
Engines
Fuel system
Ignition system
Start system
Release system
Transmissions
Coupling
- Transfer
The general description
Diagnostics
- Service out of a workshop
Oil of a distributing box
The gear change lever
The switch of transfer of the all-wheel drive car
Oil epiploons of transfer
The gauge of speed
Back fixture of the engine
The transfer module
Removal
Installation
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment
|
The switch of transfer of the all-wheel drive car
Replacement
|
|
Remove a console box and lift casings №2 and №3 levers of a transmission as it is described in the Head the Mechanical transmission (type 1), in Section the gear change Lever.
Remove a casing №2 (4) levers of transfers, disconnect wires on the transfer case to release it, and extend фитинг (1).
Replace the switch of a full drive (3) and connect, as was originally. The inhaling moment (a): 20 Н•м (2.0 kg th, 14.5 pounds-foots).
|
|
1 — фитинг
2 — a clip
3 — the switch of a full drive
4 — a casing №2 |
Include the ignition switch, switch the gear change lever in position 4WD (a full drive) and check up, that the indicator burnt. After check switch off the switch.
|
|
- At removal and switch installation be accurate, that the dust has not got in a transmission.
- Do not forget to establish a clip on wires which are located so that them it is not visible.
- It is recommended to work with a casing №1 levers of a gear change from the bottom access when the car is lifted.
|
|
|
Check
|
|
Disconnect a clip and фитинг the switch of a full drive.
Work of the switch (2) switchings of a full drive can be checked up.
|
|
1 — an ohmmeter
2 — the switch |
On these contacts there should be a conductivity when the switching lever is switched in position 4H and 4L.
On termination of check connect фитинг and a clip of wires as was originally.
|
|
At switch replacement be accurate, that the dust has not got to transfer through a switch aperture. |
|
|
|
|