Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
Brake system
Engines
Fuel system
Ignition system
Start system
Release system
Transmissions
Coupling
Transfer
- Forward and back differentials
- Forward диффренциал
The general description
Diagnostics
- Service out of a workshop
Servicing
- Check
Control system of a full drive
Drive
The air pump
Removal and installation
Removal
Installation
Back differential
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment
|
Drive
|
|
Disconnect a hose for air from the pump and establish on a hose the special tool. Ослабьте an adjusting bolt on the special tool. The special tool (A): 09918-18110.
Attach an air hose of the compressor to the special tool. Start up air and turn an adjusting bolt to receive the specified pressure. The specified pressure: 30.0 кПа (0.3 kg/sm2, 4.25 pounds on sq. inch).
|
|
Do not lift pressure above 200 кПа (2.0 kg/sm2, 28.4фунта on sq. inch) as it can damage a diaphragm. |
|
|
1 — the differential case
2 — an adjusting bolt
3 — to air compressor |
|
|
Lift the car so that forward wheels did not concern the earths, turn one forward wheel a hand and check up other wheel which should behave as follows:
When pressure from the compressor arrives to the actuator: the second forward wheel should turn in a direction opposite to volume in which you rotated the first wheel a hand.
When pressure from the compressor does not arrive to the actuator: the second forward wheel should remain motionless whereas the wheel which rotated a hand, should rotate.
|
If result unsatisfactory, check up differential as it is described in the Head Forward and back differentials, in Section Check (the module Repair manual).
|
|
|
|