Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
- Suspension bracket
   - Forward suspension bracket
      The general description
       Diagnostics
      - Service out of a workshop
         The stabilizer of cross-section stability/plug
         Shock-absorber rack
         Cylindrical spring
         The terminator of a dynamic course of a suspension bracket / a rubber nest of a spring
         Wheel nave (including the wheel bearing)
         Sharnir/os rotations
         The suspension bracket/plug lever
    Back suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
Brake system
Engines
Fuel system
Ignition system
Start system
Release system
Transmissions
Coupling
Transfer
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment





Shock-absorber rack

Removal

 PERFORMANCE ORDER

  1. Remove a bar of a rack (1) (if is available).
  1. Lift the car that the forward suspension bracket freely hung.
  2. Remove a wheel.
  1. Remove the E-shaped ring (1) protecting a brake hose, and remove a brake hose with скобы racks, as shown.
  1. If there is a system of antiblocking of brakes (ABS), remove a bolt (1) plugs of a wire of the gauge of speed of a forward wheel.
  1. Remove bolts скобы racks (1), then a jack (3) bottom lever (2).
  1. Remove nuts of a support of a rack (1). Hold a rack with a hand that it has not fallen.
  1. Remove a rack.
  1. Remove a nut of a rack (1), the top nest (2), a support (3), пыльник (4) and the bottom nest (5) from a rack of the shock-absorber (6).

Installation

 PERFORMANCE ORDER

  1. Establish a rack, carrying out in return sequence steps on its removal 1 – 9. Put bolts in the specified direction.
1 — a shock-absorber rack
2 — the bottom nest
3 — пыльник
4 — a rack support
5 — the top nest
6 — a rack nut
  1. Tighten all fixing elements to the specified values of the moment of an inhaling.
    • The inhaling moment:
      • Rack nut (a): 90 Н•м (9.0 kg th, 65.0 pounds-foots)
      • Nut of a support of a rack (b): 55 Н•м (5.5 kg - of m, 40.0 pounds-foots)
      • Bolt скобы (c): 95 Н•м (9.5 kg th, 69.0 pounds-foots)
      • Bolt (d): 50 Н•м (5.0 kg th, 36.5 pounds-foots)

  • Installation of a brake hose.
  • At installation of a hose do not overwind it. Establish the E-shaped ring (1), without falling outside the limits a surface скобы (2).