Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
Brake system
Engines
Fuel system
Ignition system
- Start system
The general description
- Diagnostics
Block repair
Analysis
Assemblage
Survey
Work check
Specifications
Type 0.9 кВ
Necessary materials
The special tool
Release system
Transmissions
Coupling
Transfer
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment
|
Analysis
|
|
- Before starter analysis, necessarily arrange a mark in those places (A and B) to avoid possible errors.
- Do not clamp a collar a vice and do not beat on it a hammer at repair.
|
|
|
1 — the electromagnetic switch
2 — a forward casing
3 — a collar |
|
|
Remove a protector (if is) and the electromagnetic switch.
|
|
1 — the electromagnetic switch
2 — a protector |
|
|
Do not assort this switch. If it is faulty, replace it as assemblage. |
|
|
1 — the electromagnetic switch
2 — a spring
3 — the piston |
Remove bolts, then disconnect assemblage of a reducer from starter assemblage.
|
|
1 — bolts
2 — reducer assemblage |
To repair reducer assemblage, remove a lining and planetary transfers.
|
|
1 — planetary transfer
2 — a lining |
Remove rubber consolidation and a plate.
|
|
1 — rubber consolidation
2 — a plate |
Remove lever assemblage together with the lever.
|
|
1 — lever assemblage
2 — the lever |
Release the lock ring of a gear fixed by a persistent ring.
|
|
1 — a persistent ring
2 — a lock ring of a gear
3 — assemblage обгонной муфты |
Remove a persistent ring, then extend a lock ring of a gear, обгонную муфту and internal transfer. The special tool (A): 09900-06107.
|
|
1 — internal transfer
2 — a persistent ring
3 — a lock ring of a gear
4 — обгонная муфта |
Remove back скобу and щеткодержатель.
|
|
1 — back скоба
2 — an anchor
3 — a collar |
Remove an anchor from a collar and then a ball from the end of a shaft of an anchor.
|
|
1 — an anchor
2 — a collar
3 — a ball |
Remove щеткодержатель with back скобы.
|
|
1 — back скоба
2 — щеткодержатель |
|
|
Remove springs of brushes and a brush.
|
Remove a cap back скобы, and then remove a back sleeve.
|
|
1 — back sleeves
2 — a cap back скобы
3 — back скоба |
|
|
|
|