Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
Brake system
Fuel system
Ignition system
- Start system
    The general description
   - Diagnostics
      Block repair
      Work check
      Type 0.9 кВ
   Necessary materials
   The special tool
Release system
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment

Work check

Each check should be carried out within 3-5 seconds that the coil has not fused.

Retraction check


    Connect the battery to the electromagnetic switch as shown more low. Check up that the piston and a gear come to light. If the piston and a gear do not move, replace the electromagnetic switch.

Before check, disconnect a wire wire from conclusion M.

1 — a conclusion ' S'
2 — a conclusion ' M'
3 — a wire conclusion (the switch on the motor)
4 — a conclusion ' In'

Keeping check


    At connection as it is specified above with the put forward piston, disconnect a negative wire from a conclusion ' M '.
    Check up that the piston and a gear remain outside. If the piston and a gear come back back, replace the electromagnetic switch.

Check of return of the piston and gear

Disconnect a negative wire conclusion from the switch case. Check up that the piston and a gear come back inside. If the piston and a gear do not come back, disassemble and check up a starter.

Check of work without loading


    Connect the battery and the ampermeter to a starter as shown.
    Check up that the starter rotates smoothly and constantly, and the gear moves outside. Check up that the ampermeter shows a current, as указанно. The specified current: 90 A MAX. At 11 Century

Use thicker wires and completely tighten each conclusion.