Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
Brake system
Engines
Fuel system
Ignition system
- Start system
The general description
- Diagnostics
Block repair
Analysis
Assemblage
Survey
Work check
Specifications
Type 0.9 кВ
Necessary materials
The special tool
Release system
Transmissions
Coupling
Transfer
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment
|
Assemblage
|
|
- It is not authorised to wash out, regulate or assort the shock-absorber (a disk муфты coupling).
- New bearings without greasing have been greased, when were delivered as spare parts. Do not wash out маслорастворителем and do not grease with other lubricant substance.
|
|
|
Check up components (Survey see) and replace on new if necessary.
Put greasing (the Starter see).
Establish an anchor on a collar.
Establish brushes and springs of brushes on щеткодержатель.
Establish щеткодержатель on an anchor, squeezing out 4 brushes outside.
|
|
1 — a brush
2 — a brush spring
3 — щеткодержатель |
Establish a back sleeve and then a cap back скобы.
Establish back скобу.
Tighten screws щеткодержателя.
|
|
1 — back скоба
2 — screws щеткодержателя |
Establish assemblage обгонной муфты on a shaft - a gear wheel, paying attention to a direction of installation of a lock ring of a gear.
|
|
1 — обгонная муфта
2 — a lock ring of a gear
3 — a persistent ring
4 — a shaft-gear wheel |
Insert shaft assemblage into a forward casing, lever position.
|
|
1 — lever assemblage
2 — the lever |
Establish a lining so that cuts in it were combined with apertures for through bolts in a forward casing.
Establish a plate and rubber consolidation in a forward casing.
|
|
1 — a lining
2 — planetary transfer
3 — an aperture for a bolt
4 — rubber consolidation |
Put greasing on a ball and establish a ball in a shaft aperture.
Establish a collar, an anchor, щеткодержатель and back скобу in a forward casing, having combined the marks put before removal.
Tighten through bolts.
|
|
1 — bolts
2 — reducer assemblage |
Establish assemblage of the electromagnetic switch and a protector (if is). Connect a wire (to the motor) to a switch conclusion.
After the termination of assemblage inspect work.
|
|
1 — the electromagnetic switch
2 — a protector |
|
|
|
|