Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
- Brake system
   - Brakes
      The general description
       Diagnostics
      The diagnostic table
      - Check and adjustment
         Стравливание air from brakes
         Check of free height of the brake lever
         Adjustment of the light switch of brakes
         Check it is superfluous a pedal course
         Check of a free wheeling of the brake lever
         Check of level of a brake liquid
         Check of a brake hose and highway
         Check of the main cylinder
         Check of a brake disk
         Check brake колодки
         Check of a brake boot
         Check and adjustment of a lay brake
         Washing of hydraulic system of brakes
         Check of pressure of a liquid (if the car is equipped LSPV)
         Check of work of the brake amplifier
      Specifications - an inhaling twisting moment
      Necessary materials for service
      The special tool
    Brake highway/hose the brake cylinder
    Forward brakes
    Lay and back brake
    Antiblocking brake system (ABS)
Engines
Fuel system
Ignition system
Start system
Release system
Transmissions
Coupling
Transfer
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment


Service desk программа узнать больше.




Check of a brake boot

Survey should be spent in following points after the course of the brake lever c (a backlash between a pedal and bitumen sheet) is checked up as is described in point Check of a superfluous course of a pedal in the given section even if it exceeds 115 mm (4.53 inches). Degree of deterioration brake колодки can be checked up as follows.

 PERFORMANCE ORDER

    Raise a vehicle. Remove rubber заглушку (1) from a board of a drum-type brake. Through an aperture in a board visually check up a thickness колодки a brake overlay (2). If the thickness of an overlay f is less, than the specified limit of deterioration, replace brake колодки with the new. A thickness back brake колодки f: a deterioration limit — 1.0 mm (0.04 inches).
1 — rubber заглушка
2 — a brake overlay
3 — a rim brake колодки