Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
- Brake system
- Brakes
The general description
Diagnostics
The diagnostic table
- Check and adjustment
Стравливание air from brakes
Check of free height of the brake lever
Adjustment of the light switch of brakes
Check it is superfluous a pedal course
Check of a free wheeling of the brake lever
Check of level of a brake liquid
Check of a brake hose and highway
Check of the main cylinder
Check of a brake disk
Check brake колодки
Check of a brake boot
Check and adjustment of a lay brake
Washing of hydraulic system of brakes
Check of pressure of a liquid (if the car is equipped LSPV)
Check of work of the brake amplifier
Specifications - an inhaling twisting moment
Necessary materials for service
The special tool
Brake highway/hose the brake cylinder
Forward brakes
Lay and back brake
Antiblocking brake system (ABS)
Engines
Fuel system
Ignition system
Start system
Release system
Transmissions
Coupling
Transfer
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment
|
Check and adjustment of a lay brake
Check
|
|
|
|
Undertake the centre of the handle of a lay brake and pull it upwards with effort of 20 kg (40 pounds).
|
When the lever of a lay brake will pull upwards count ratchet marks. Should be 5 - 7 marks.
Also check up, whether the right and left back wheels are reliably blocked. That it was easier to consider marks, listen to ratchet clicks at a raising of the lever of a lay brake, without pressing the button.
One click corresponds to one mark. If the quantity of marks does not correspond to the specification, adjust a cable having addressed to procedure of the adjustment described more low to receive a necessary course of a lay brake.
|
|
Check up, are not damaged and whether heads of a tooth of each mark are worn out. If damages or deterioration are found out, replace the lever of a lay brake. |
|
|
Adjustment
|
|
Before cable adjustment be convinced that following conditions are met:
- In brake system there is no air.
- Course of the brake lever such as it is required.
- The brake lever has been pressed some times with effort about 30 kg (66 pounds).
- The lever of a lay brake (1) has been some times lifted with effort about 20 kg (44 pounds).
|
|
|
If the cable of a lay brake is replaced on new, lift the lever of a lay brake some times with effort about 50 kg.
Back brake колодки are not worn out beyond the limit, and the self-regulation mechanism works properly.
To weaken a cable of a lay brake (2), release самоконтрящуюся a nut (3) till the end of a bolt. Then press the brake lever a little with effort about 30 kg (66 pounds).
Having convinced that all are met specified above a condition, adjust a course of the lever of a lay brake, having released or having tightened a lock nut.
|
|
Check up, whether заедает a brake drum after adjustment. |
Course of a lay brake (when the lever is lifted with effort 200 Н•м (20 kg, 44 pounds) - 5 - 7 marks. |
|
|
|