Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
- Brake system
   - Brakes
      The general description
       Diagnostics
      The diagnostic table
      - Check and adjustment
         Стравливание air from brakes
         Check of free height of the brake lever
         Adjustment of the light switch of brakes
         Check it is superfluous a pedal course
         Check of a free wheeling of the brake lever
         Check of level of a brake liquid
         Check of a brake hose and highway
         Check of the main cylinder
         Check of a brake disk
         Check brake колодки
         Check of a brake boot
         Check and adjustment of a lay brake
         Washing of hydraulic system of brakes
         Check of pressure of a liquid (if the car is equipped LSPV)
         Check of work of the brake amplifier
      Specifications - an inhaling twisting moment
      Necessary materials for service
      The special tool
    Brake highway/hose the brake cylinder
    Forward brakes
    Lay and back brake
    Antiblocking brake system (ABS)
Engines
Fuel system
Ignition system
Start system
Release system
Transmissions
Coupling
Transfer
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment






Check of work of the brake amplifier

There are two ways of performance of this survey, with a tester and without it. It is usually possible to define approximately a condition without tester use.

For carrying out of the given check, be convinced that in a hydraulic highway there is no air.

Survey without a tester

Air impermeability check

 PERFORMANCE ORDER

    Start the engine. Stop the engine after it will work 1-2 minutes. Press some times the brake lever with that effort, as at usual braking and pay attention to a pedal course. If the pedal the first аз leaves deeply, but its course decreases at the second and the subsequent pressing, necessary degree of air impermeability is reached.
1 — 1st
2 — 2nd
3 — 3rd
    If the pedal course does not vary, necessary degree of air impermeability, is not reached.

In case of malfunction, examine vacuum lines of consolidation and replace any faulty elements.

    After that repeat all procedure of check.
1 — 1st, 2nd, 3rd

Work check

 PERFORMANCE ORDER

    When the engine is stopped, some times press the brake lever with the same effort and be convinced that the pedal course does not vary. Start the engine, having pressed the brake lever. If the course of a pedal increases a little, the brake works normally. If the pedal course does not vary, it testifies to malfunction.

Air impermeability check under loading

 PERFORMANCE ORDER

    When the engine works, press the brake lever. Then stop the engine, keeping the brake lever the pressed.
H — keep
    Keep the brake lever pressed during 30 seconds. If the pedal height does not vary, a condition of a brake the good. But if the pedal rises, a condition of a brake the bad.

H — keep
T — 30 seconds