Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
- Brake system
   - Brakes
      The general description
      The diagnostic table
      - Check and adjustment
         Стравливание air from brakes
         Check of free height of the brake lever
         Adjustment of the light switch of brakes
         Check it is superfluous a pedal course
         Check of a free wheeling of the brake lever
         Check of level of a brake liquid
         Check of a brake hose and highway
         Check of the main cylinder
         Check of a brake disk
         Check brake колодки
         Check of a brake boot
         Check and adjustment of a lay brake
         Washing of hydraulic system of brakes
         Check of pressure of a liquid (if the car is equipped LSPV)
         Check of work of the brake amplifier
      Specifications - an inhaling twisting moment
      Necessary materials for service
      The special tool
    Brake highway/hose the brake cylinder
    Forward brakes
    Lay and back brake
    Antiblocking brake system (ABS)
Fuel system
Ignition system
Start system
Release system
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment

Adjustment of the light switch of brakes

Do not apply any lubricant oil or greasing (including anticorrosive, lubricant, etc.) with specified more low sections.

  • The switch of a stoplight (1) (including its top part (2)).
  • The switch (2) adjoining to скобе of the brake lever (3).

If to use oil or greasing, they can get on contacts of the switch and cause their refusal. Also at check, adjustment or replacement of the brake switch, check up that oil or greasing have not got to the zone of the switch adjoining a brake pedal or the top part of the switch. Erase the oil which has got to this zone or greasing.

At installation of the switch of a lamp of a brake (1) adjustment should be carried out as follows.


    Pull the brake lever on itself and keeping it in this position, adjust switch position so that a backlash between the end of a carving and скобой the brake lever (designated as "an" or b in drawing more low). Then tighten a lock nut with the specified twisting moment of an inhaling (if it is specified).
      Backlash between the end of a carving and скобой the brake lever
        For having a lock nut
          Type a: 1.5 - 2.0 mm (0.06 - 0.08 inches)
        For not having a lock nut
          b: 0.5 - 1.5 mm (0.02 - 0.06 inches)
        The inhaling moment
          Lock nut of the switch of a lamp of a brake (a): 7.5 Н•м (0.75 kg th, 5.5 pounds on foot)
A — for having a lock nut
B — for not having a lock nut