Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
- Brake system
Brakes
Brake highway/hose the brake cylinder
Forward brakes
- Lay and back brake
The general description
- Diagnostics
Check and adjustment
Vehicle service
Cable of a lay brake
Brake drum
Brake колодка
The brake cylinder
Back plate of a brake
Antiblocking brake system (ABS)
Engines
Fuel system
Ignition system
Start system
Release system
Transmissions
Coupling
Transfer
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment
|
The brake cylinder
Removal
|
|
Execute item 1 - 6 procedures of removal Has undressed the Brake drum.
Execute item 2 - 4 procedures of removal of Section Brake колодка.
Release накидную a nut of a brake highway (or nuts) but only so that the liquid did not follow.
|
|
Remove adjusting boats of the wheel cylinder. Disconnect a brake highway (or highways) from the wheel cylinder and establish a cap of a stopper of a safety valve of the wheel cylinder (1) in a highway not to allow a liquid to pour out.
|
|
|
Survey
|
|
Examine the wheel cylinder, whether there are no wear tracks, cracks, corrosion or damages. |
|
|
Clear components of the wheel cylinder of a brake liquid. |
Installation (for not soldered type)
|
|
|
|
Remove a cap of a stopper of a safety valve from a brake highway and connect a highway (or highways) to the wheel cylinder (1) so that the liquid did not proceed.
|
|
|
Tighten the wheel cylinder on a back plate of a brake (1) according to an inhaling twisting moment. An inhaling twisting moment: a bolt of the wheel cylinder (a): 13 Н•м (1.3 kg th, 9.5 pounds-foots).
|
The inhaling twisting moment накидной nuts (2) (or nuts) a brake highway (3) which has been connected in item 1 above, should correspond to the specification. An inhaling twisting moment: накидная a nut of a brake highway (b) — 16 Н•м (1.6 kg th, 12.0 pounds-foots).
Establish a cap of a stopper of the safety valve, removed from a highway, back on a cap of a stopper of a safety valve.
Then address to item 1 - 6 procedures of installation of Section Brake колодка.
|
|
|
|