Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
Brake system
- Engines
Mechanical part of engine G16
Mechanical part of engine J20
- Engine cooling
The general description
Diagnostics
Maintenance service
- Vehicle routine maintenance
Plums of a cooling liquid
Hoses or water pipes of system of cooling
The thermostat
Belt of the cooling fan
The cooling fan and муфта the fan
Radiator
The water pump
The gauge of temperature of a cooling liquid of the engine (EATS)
Necessary service materials
Technical characteristics of the rotating moment of an inhaling
Fuel system
Ignition system
Start system
Release system
Transmissions
Coupling
Transfer
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment
|
Hoses or water pipes of system of cooling
Removal
For engines G16 and J20
|
|
Disconnect a negative cable (-) from the accumulator.
Merge cooling system.
Untwist screws on each pipe or ослабьте clips of hoses and pull the hose end to remove these pipes or hoses.
Remove the case throttle заслонок and an inlet collector
|
|
Installation
For engines G16 and J20
|
|
Establish the removed parts as it should be the return to dismantle procedure, without forgetting about the following.
Reliably fasten everyone tightening a bolt.
|
|
At installation of a water exhaust pipe (1) to a cylinder head, put hermetic on a carving of a bolt of a pipe and then fasten it (only for engine J20). Hermetic "And": 99000-31110.
|
Fill system of cooling with a corresponding cooling liquid, having addressed to the description in Sections the Cooling liquid and Washing and filling of system of cooling in this Chapter.
Check up each part on a leaking.
|
|
|
|