Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
Brake system
- Engines
    Mechanical part of engine G16
    Mechanical part of engine J20
   - Engine cooling
       The general description
       Diagnostics
       Maintenance service
      - Vehicle routine maintenance
         Plums of a cooling liquid
         Hoses or water pipes of system of cooling
         The thermostat
         Belt of the cooling fan
         The cooling fan and муфта the fan
         Radiator
         The water pump
         The gauge of temperature of a cooling liquid of the engine (EATS)
      Necessary service materials
      Technical characteristics of the rotating moment of an inhaling
Fuel system
Ignition system
Start system
Release system
Transmissions
Coupling
Transfer
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment





Radiator

Removal

 PERFORMANCE ORDER

    Disconnect a negative cable (-) from the accumulator.
    Merge cooling system, having turned off a drain stopper (1) radiators.
    At service of vehicles А/Т place маслосборник under a radiator (1) and disconnect hoses for liquid А/Т (2), (3) from a radiator.
    Turn off nuts of the cooling fan/mufty (1).
    Disconnect an inlet hose of a radiator from a radiator.
    Remove распорные bolts of the tank of liquid P/S (1) from a radiator rack.
    Remove safety clips of a casing of the fan. Then remove cooling fan/muftu and a radiator casing.
    Disconnect a water inlet and final hose (1), (2) and a hose of the tank (3) from a radiator.
    Remove a radiator (4).

Check

Check up a radiator about a leaking or damage. Straighten погнутые plates if those are.

Cleaning

Clean a forward part of a core of a radiator.

Installation

Repeat dismantle procedure upside-down, without forgetting as follows.

 PERFORMANCE ORDER

    Fill system of cooling with a corresponding cooling liquid, having addressed to Sections the Cooling liquid and Washing and filling of system of cooling in this Chapter. Adjust a tension of a belt of the cooling fan according to technical requirements. Address to Section Regulation and check of a tension of a belt of the cooling fan in this Chapter. In vehicles А/Т check up level of liquid А/Т, having addressed to Section liquid Level in the Head the Automatic transmission (4 A/T). After installation check up each connection, whether there is no leak.