Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
Brake system
- Engines
    Mechanical part of engine G16
    Mechanical part of engine J20
   - Engine cooling
       The general description
       Diagnostics
       Maintenance service
      - Vehicle routine maintenance
         Plums of a cooling liquid
         Hoses or water pipes of system of cooling
         The thermostat
         Belt of the cooling fan
         The cooling fan and муфта the fan
         Radiator
         The water pump
         The gauge of temperature of a cooling liquid of the engine (EATS)
      Necessary service materials
      Technical characteristics of the rotating moment of an inhaling
Fuel system
Ignition system
Start system
Release system
Transmissions
Coupling
Transfer
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment





Belt of the cooling fan

Removal

For engines G16

 PERFORMANCE ORDER

  1. Disconnect a negative cable (-) from the accumulator.
  2. Turn off an adjusting bolt приводного a belt of pump P/S and then remove pump P/S belt.
  1. Turn off an adjusting bolt (1) and шарнирный a bolt.
  1. Ослабьте a belt, having displaced the generator, and then remove it.

For engine J20

 PERFORMANCE ORDER

  1. Disconnect a negative cable (-) from the accumulator.
  1. Untwist an adjusting bolt (1) and шарнирный a bolt (2).
  1. Ослабьте a belt, having displaced a fan pulley.
  2. Remove cooling pump. Simply disconnect the fan/muftu from a fan pulley.
  3. Remove a belt of the cooling fan (3).

Installation

For engines G16

 PERFORMANCE ORDER

  1. Establish a belt on a pulley of the water pump, a pulley коленвала and a generator pulley. Establish приводной pump P/S belt.
  2. Adjust a belt tension as it is specified. Address to Section Regulation and check of a tension of a belt of the cooling fan in this Chapter.
  3. Twirl an adjusting bolt and шарнирный a bolt.
  4. Connect a negative cable (-) to the accumulator.

For engine J20

 PERFORMANCE ORDER

  1. Establish a belt to a pulley of the fan and a pulley коленвала.
  2. Establish cooling fan. Address to Razdelu Mufta of the fan of cooling system in this Chapter.
  3. Adjust a belt tension as it is specified. Address to Section Regulation and check of a tension of a belt of the cooling fan in this Chapter.
  4. Twirl an adjusting bolt and шарнирный a bolt.
  5. Connect a negative cable (-) to the accumulator.

Check of a tension of a belt of the cooling fan

Examine a belt and check up a belt tension. Address to Section Regulation and check of a tension of a belt of the cooling fan in this Chapter.