Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
Brake system
- Engines
    Mechanical part of engine G16
   - Mechanical part of engine J20
       The general description
      - Routine maintenance
         Compression check
         Check of depression of the engine
         Check of pressure of oil
         Filtering element of the air filter
         The case throttle заслонок and an inlet collector
         Exhaust system collector
         Cover of a head of the cylinder
         Маслосборник and a grid of the oil pump
         The oil pump
         Cover of a chain of synchronisation
         The second chain of synchronisation and натяжитель chains
         The first chain of synchronisation and натяжитель chains
         Cam-shafts and regulators клапанного a backlash
         Valves and head of the block of the cylinder
         Pistons, piston rings, rods and cylinders
       Assembly armature of the engine
      The special tool
      Necessary service materials
      Technical characteristics of the rotating moment of an inhaling
    Engine cooling
Fuel system
Ignition system
Start system
Release system
Transmissions
Coupling
Transfer
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment






Routine maintenance

Compression check

 PERFORMANCE ORDER

    Check up pressure of compression upon all four cylinders as follows. Warm up the engine. After a warming up stop the engine.

After an engine warming up put the gear change lever on "Neutral" (for models А/Т put the gear change lever in position Р), both establish a lay brake and block приводные wheels.


    Disconnect a cable of an accelerator (3) from a clip (4) (only for vehicles with the left wheel).
    Disconnect муфты ignition coils. Remove coils of ignition (1). Remove all spark plugs (2). Disconnect wires of a fuel injector from муфты (5).
    Establish the special tool (компрессиметр) in a spark plug aperture.
      The special tool
        (): 09915-64510-001 (): 09915-64510-002 (): 09915-64530 (D): 09915-67010
    Switch off coupling (to reduce initial loading by the engine) for models М/Т, and press a pedal of management of giving of fuel against the stop completely to open throttle заслонку.
    Start the engine with completely charged accumulator and read the maximum instrument of pressure on компрессиметре.

To measure pressure of compression, start the engine, at least, on 250 turns in a minute, with the help of completely charged accumulator.

Technical characteristics pressure of compression

 

Pressure of compression

The normal

1400 кПа (14.0 kg/sm2, 199.0 пси)

The limiting

1200 кПа (12.0 kg/sm2, 170.0 пси)

The maximum deviation between two cylinders

100 кПа (1.0 kg/sm2, 14.2 пси)

    Execute points 9 - 11 on each cylinder to read four instruments.
    After check insert spark plugs (2) and coils of ignition (1).
    Connect муфты ignition coils. Connect a cable of an accelerator (3) to a clip (4) (only for vehicles with the left wheel).