Suzuka Grandee Vitara
The general information
Maintenance service and greasing
Heater, ventilation and the conditioner
Steering
Suspension bracket
Wheels and tyres
Forward приводной a shaft shaft/bearing. An oil epiploon
Kardannye shaft
Brake system
- Engines
Mechanical part of engine G16
- Mechanical part of engine J20
The general description
- Routine maintenance
Compression check
Check of depression of the engine
Check of pressure of oil
Filtering element of the air filter
The case throttle заслонок and an inlet collector
Exhaust system collector
Cover of a head of the cylinder
Маслосборник and a grid of the oil pump
The oil pump
Cover of a chain of synchronisation
The second chain of synchronisation and натяжитель chains
The first chain of synchronisation and натяжитель chains
Cam-shafts and regulators клапанного a backlash
Valves and head of the block of the cylinder
Pistons, piston rings, rods and cylinders
Assembly armature of the engine
The special tool
Necessary service materials
Technical characteristics of the rotating moment of an inhaling
Engine cooling
Fuel system
Ignition system
Start system
Release system
Transmissions
Coupling
Transfer
Forward and back differentials
Windows, mirrors, locks and security measures. An immobilizer
Electric equipment
|
Cover of a head of the cylinder
|
|
Disconnect a negative cable from the accumulator.
Disconnect муфты ignition coils.
Remove knots of the coil of ignition.
Separate a rope of an accelerator from a clip (only for vehicles with the left wheel).
Take out oil щуп (1).
|
|
Disconnect a hose сапуна (2) and a hose of compulsory ventilation картера (3) from a cover of a head of the cylinder.
|
Uncover cylinder heads.
|
|
Installation
|
|
Erase oil, old hermetic and a dust from condensed surfaces on a head of the cylinder and a cover.
Establish ring consolidations (3) and a lining of a cover of a head of the cylinder (2) on a cover of a head of the cylinder (1).
|
|
Do not forget to check up each of these details on presence of any damages or breakages before installation, and make replacement if damages are found out. |
|
|
Establish a lateral sealant (4) on a cylinder head.
|
|
|
After clearing put hermetic "And" on area of a condensed surface of a head of the cylinder. "And": hermetic 99000-31250.
|
Establish a cover of a head of the cylinder on a cylinder head. Fasten nuts (3) while they will not be fastened with the specified rotating moment. The rotating moment of an inhaling: a nut of a cover of a head of the cylinder () — 11 Н•м (1.1 kg th, 8.0 pound on foot).
|
|
Use new sealing washers (1).
|
Establish coils of ignition and connect муфты ignition coils.
Insert oil щуп (2).
Connect a hose сапуна and a hose of compulsory ventilation картера to a cover of a head of the cylinder.
Fix a rope of an accelerator a clip (only for vehicles with the left wheel).
|
|
|
|